Burkert 8695 Manuel D'utilisation page 24

Figure 14: Installing the control head, series 20xx
noTe!
too high torque when screwing in the fastening screw does not ensure degree of protection ip65 /
ip67.
▶ The fastening screws may be tightened to a maximum torque of 1.5 Nm only.
→
Attach the control head to the actuator using the two side fastening screws. In doing so, tighten the fastening
screws hand-tight only (maximum torque: 1.5 Nm).
24
All manuals and user guides at all-guides.com
Fastening screws
maximum 1.5 Nm
english
Type 8695
Installation