Arneg Perth 6P Manuel D'installation Et De Service page 56

Perth 6P - Pelican 6P
English
2 gently place them on a fl at surface, DO NOT break or damage them
3 clean as indicated for the glass parts (chapter 24.5)
4 reinstall the closures
24. 7 Clean specifi c materials
Material
Glass
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water and detergent with a dry
cloth in order to prevent marks
from forming and to prevent liquid
from reaching the gaskets, frame,
or the glass door hinges.
• use a cloth soaked in neutral deter-
Plasti c
gent
(door seal
• clean with a cloth soaked in clean
profi les)
water
Aluminium • use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
Wood • before cleaning the enti re surface,
test on a small hidden area and ver-
ify that the cleaner will not damage
the fi nish or colour
• use a soft cloth with a neutral de-
tergent or soap and lukewarm wa-
ter (max 30°C)
• immediately remove all traces of
water or detergent using a dry
cloth in order to prevent marks
from forming
24. 8 Clean the stainless steel
Certain situati ons can cause the formati on of rust on the surfaces in steel, such as:
iron remains left on damp surfaces, limestone, chlorine or ammonia based detergents not rinsed
properly, food incrustati ons or residues, salt-saline soluti ons, dry residues of evaporated liquids.
recent stains and rust:
Remedy
clean with shampoo or neutral detergents, using a sponge or a rag.
When fi nished, eliminate any detergent residue, rinsing abundantly and thoroughly
drying the surfaces.
old stains and rust:
use chemical substances on the stainless steel that contain 25% of nitric acid or similar
substances.
persistent stains and rust:
sand with a stainless steel brush, wash with detergent and dry thoroughly.
CAUTION! Slippery fl oor. Falling.
Remove from the fl oor any items such as sponges, rags, waste of water or detergent.
Carefully remove all detergent residues.
52
Remedy
This interventi on may however cause scratches to the surfaces due to the
abrasive cleaning method. DO NOT use hydrochloric acid on stainless steel
surfaces
What to avoid
• DO NOT use hot water on cold glass surfaces;
the glass could crack and injure the operator
• DO NOT use rough or abrasive materials or
metal scrapers that could scratch the glass
surfaces
• DO NOT use dirty cloths
• DO NOT use waxes, concentrated deter-
gents, which contain oil, bleach, glass clean-
ers, abrasive detergents or fl ammable fl uids.
• DO NOT use acid or alkaline detergents (e.g.
bleach) which could corrode the surfaces
• DO NOT use rough or abrasive materials or
metal scrapers that scratch the aluminium
surfaces
• DO NOT use steam cleaning equipment
• DO NOT use dirty cloths
• DO NOT use spray cans, acid or alkaline de-
tergents (e.g. bleach), soda or solvents which
could corrode the surfaces
• DO NOT use rough or abrasive materials that
could scratch the surfaces
• DO NOT use steam cleaning equipment
• DO NOT use rough cloths
• moderate the use of liquid detergent: over-
use causes seepage and then swelling of the
wood
05060216 00 06-2022