Arneg Perth 6P Manuel D'installation Et De Service page 48

Perth 6P - Pelican 6P
English
N°
1 manufacturer's name/logo
2 name and length of the cabinet
3 code of the cabinet
4 serial number of the cabinet
5 supply voltage
operating electrical power absorbed in the defrosting phase
6
(armoured heaters+hot wires+ fans+lighting)
7 usable display surface
8 type of refrigerant fluid used by the system to operate
9 environmental climatic class and temperature of reference
10 number of the job order based on which the cabinet has been manufactured
11 number of purchase order based on which the cabinet has been put in production
12 year of manufacture of the cabinet
13 EAC marking
14 operation class
weight of refrigerant gas loaded in every system
15
(only for cabinets with a built-in motor)
16 heating capacity
17 lighting power (where included)
18 class of protection against humidity
19 QR code
20 operating current consumption
operating electrical power absorbed in the refrigeration phase
21
(fans+hot wires+lighting)
22 Power supply frequency
i
For assistance, communicate the following to the manufacturer:
- the product name (2); the serial number (4); the job order number (16)
NEVER remove the serial number plate under any circumstances
10. Energy label (Fig.3)
According to the European Regulation EU 2019/2018, this product is part of the refrigeration ap-
pliances with a direct sales function and as such must have an energy label.
The information on the label refers to precise configurations.
Any configuration other than the one presented could result in a significant change in the informa-
tion relating to the energy class.
The energy class spans A to G, where A represents the very efficient product with low energy con-
sumption and G the product with lower efficiency and higher energy consumption.
Below is an explanation of the information on the label:
QR code, refers to the model values present in EPREL
I
supplier's trade mark or name
II
supplier model identifier
III
energy efficiency class from A to G
IV
energy efficiency class, determined in accordance with Annex II
V
AE in kWh per year, rounded to the nearest integer
VI
sum of the exposure surfaces at operating temperatures for refrigeration, expressed in
VII
square metres (m²) and rounded to two decimal places.
temperature range reached by the cooled products: at the top the maximum value of the
VIII
warmest product; at the bottom the minimum value of the coldest product
sum of the exposure surfaces at operating temperatures for freezing, expressed in square
IX
metres (m²) and rounded to two decimal places
temperature range reached by frozen products: at the top the maximum value of the warm-
X
est product; at the bottom the minimum of the highest value of all products
number of this regulation
XI
For further details, consult the European Register of Products for Energy Labelling EPREL or contact
44
Name
05060216 00 06-2022