Publicité
Les langues disponibles
Les langues disponibles
Do not use
- detergents or similar products to clean the parts in methacrylate (Plexiglass)
- in powder
alcohol-based
- with granules
- either acidic or alkaline (bleach, ammonia)
- concentrates
- with unknown chemical compositi on
- abrasive products, chemical/organic solvents
- abrasive sponges, scourers, sharp tools
- aggressive solvents (aceti c acid, citric acid etc.)
24. 2 General informati on
• The surfaces to be cleaned and the detergents and water used for cleaning must not exceed a
maximum temperature of 30°C.
• Dry the surfaces with a soft cloth
CAUTION!
Fragile surfaces, glass. Dents, scratches, corrosion, wounds, broken glass
DO NOT aim the jet directly at the varnished or plasti cised surfaces
DO NOT apply the detergents directly onto the surfaces to be cleaned
DO NOT use steam cleaning equipment
Do not use excessive force
DO NOT bring the jet too close to the dirt. This may cause injury to the operator and con-
taminate parts that have already been cleaned, as well as the environment.
avoid detergents from coming into contact with nearby products.
CAUTION!
Floor products. Vapours. Corrosion. Breathing diffi culty.
avoid contact, inhalati on.
24. 3 Cleaning of the outer parts (Daily/Weekly)
Clean all external parts of the cabinet every week. See "General instructi ons" chapter 24. 2.
24. 4 Clean the internal parts (Monthly)
Refer to chapters 24. 1 and 24. 2 and proceed as follows:
Step
remove all items from the cabinet and place in a suitable locati on to maintain the same stor-
1
age temperature
2
remove all the removable parts, such as display dishes, grid trays, etc.
3
wash with lukewarm water (max 30°C)
4
clean with an anti bacterial detergent
carefully clean the bott om tray, the drip, and the grid that protects the water drain, eliminat-
5
ing all foreign bodies that have fallen through the sucti on grid lift ing the plate of the fans
6
carefully dry using a soft cloth.
i
Should you noti ce ice built up, call a specialized technician.
24. 5 Clean the honeycomb (every 6-8 months)
Step
1
remove the screw that secures the honeycomb support
2
remove the honeycomb
3
follow the steps given in chapters 24. 1 and 24. 2
4
reassemble the honeycomb completely dry, at the same angle
24. 6 Clean the longitudinal sliding closures
Refer to chapters (chapter 24.1.), (chapter 24.2.), (chapter 24.5.) and proceed as described:
Step
1
lift and remove the closures, use both hands and wear safety gloves.
05060216 00 06-2022
Acti on
Acti on
Acti on
Perth 6P - Pelican 6P
English
51
Publicité
