Publicité
Les langues disponibles
Les langues disponibles
10.2.3 Address setting
The inverter addressing is queried during initial commissioning and when an error occurs
in the device internal storage; see section Commissioning.
10.2.4 Country settings
If settings are changed in the inverters, in some cases it may be necessary to set the
country again; see section Commissioning.
56
All manuals and user guides at all-guides.com
No country set
This message means that the country has not been set
in any of the inverters and these are all running with
their default values. This is typically the case during
initial commissioning.
The displayed country selection list in English shows all
countries whose settings are supported by all invert-
ers.
Select the correct country where your system is
installed.
Country setting: No country available for all invert-
ers
This message means that at least two inverters do not
support the same country and cannot feed into the
mains grid for legal reasons. Example:
•
Inverter 1 supports Germany, Spain and Portugal.
•
Inverter supports France, Italy and Austria.
This message remains displayed until the incompatible
inverter is replaced.
Contact your installer.
EN
734.144 | 10.48
Publicité
