Steca Grid Vision Manuel page 40

6.3 Basic settings
A number of basic settings must be performed on the newly connected remote display.
This is done via a guided commissioning process. The following applies:
• The guided commissioning process starts when:
– basic settings have not yet been performed and the remote display is switched
on for the 1st time.
– the remote display has been without power for longer than  days.
• Basic settings are performed for both the remote display and the inverters.
• A unique address from 1 – 0 must be set at every inverter. Each address may
only be assigned once in the system. More information on this is provided in the
StecaGrid 10000 3ph manual, issue Z04 or later.
The following section describes the display messages during the guided commissioning
process.
6.3.1 Language
6.3.2 Time & date
40
All manuals and user guides at all-guides.com
Use the UP and DOWN buttons in the Set Language
window to select the correct language and confirm
this selection with the SET button.

Note
The languages are displayed in the country
language.
The time, time format, date and date format must be
set in the next step.
Use the UP and DOWN buttons to browse through the
values and select the desired value using the SET but-
ton. Pressing the SET button also brings you to the
next value to be set.
Once you have set all values you must press the SET
button once more to save these settings.
The values appear in the following sequence:
Time: hours
Time: minutes
Time: format (1 / 4)
Date: year
Date: month
Date: day
Date: format (Day Month Year; Month Day Year; Year
Month Day )
EN
734.144 | 10.48