Steca Grid Vision Manuel page 41

EN
6.3.3 Enter the number of inverters and the addresses of the in-
verters.
734.144 | 10.48
All manuals and user guides at all-guides.com

In the next step you must enter the number of invert-
ers and the addresses of the inverters in a list:
Use the UP and DOWN buttons to select the number
1.
of inverters.
Confirm this by pressing the SET button.
.
The address list now contains the selected number
of inverters and the address field of inverter 1 is
active.
Use the UP and DOWN buttons to set one of the
3.
inverter addresses.
Confirm this by pressing the SET button. The ad-
4.
dress field of inverter 2 is now active (if present).
5. Repeat steps 3 and 4 above until all inverter ad-
dresses have been entered. The next step is:
- Setting the country (see the following sec-
tion Country setting; you may need to wait
a few seconds at the System daily yield
screen).
- Jump into the address list to the first incor-
rect inverter entry if duplicate addresses have
been assigned.
You also need to go through the entire address
list from the first incorrect inverter entry to the
end of the list.
Note
After step , the list entries are not yet specifically
assigned to actual physical inverters. This occurs in
step 4.
41