Steca Grid Vision Manuel page 42

6.3.4 Country settings

NOTE
Setting the country also defines the local regulations for feeding electricity into the
mains grid. In accordance with the grid feed safety regulations, the country can only be
set once and cannot be subsequently changed.
The remote display queries all inverters for the countries that are currently set and all
countries that are supported. Four possible cases can occur:
Case 1: No inverters have a country set (standard)
Case 2: Different countries are set in the inverters
See section Settings window / Country setting in chapter Messages.
Case 3: No common country setting is available in the inverters
See section Settings window / Country setting in chapter Messages.
Case 4: A country has been preset in the inverters at the factory.
If a country has been preset at the factory you are not asked to set the country (country
selection screen is not displayed).
Check that the correct country is set in the Settings / Country screen. If the cor-

rect country is not set then notify a service technician in order to reset the country
setting.
4
All manuals and user guides at all-guides.com
1. Use UP / DOWN to select a country (Fig. left).
Note: If your country is not displayed then select
a country with values as close as possible to your
country; see Country table in the Technical Data
section of the StecaGrid 10000 3ph manual.
. Press SET. The confirmation prompt is displayed.
3. Select Confirm (Fig. left).
4. Press SET. The System daily yield screen is
displayed.
EN
734.144 | 10.48