Publicité
Les langues disponibles
Les langues disponibles
Operation
! NOTE: The touch screen display needs to be touched once before activating any functions below.
Standby
Heat
Heat Disable
Increase
Temperature
Decrease
Temperature
Temperature
Display
(°C ↔ °F)
Flame Intensity
Extractor Fan
Boost
Ambient &
Flame Theme
Brightness
20
Press
to turn on the unit or to put it in standby mode. There is a brief delay after
pressing
before the unit turns on.
When the unit is turned on, there is a 3-minute warm-up sequence before the flame
effect starts.
Press
to turn the heat on or off.
When the heat is turned on, the display briefly indicates the set temperature (##ST),
followed by the ambient room temperature.
When the heat is turned off, the fan continues to operate for a further 30 seconds to
dissipate residual heat.
Press and hold
and
function. This action must be performed on the hidden touch controls.
When the heat is disabled and
Press
to increase the temperature setting.
The temperature can be set from 15° C to 30° C (59° F to 86° F).
Press
to decrease the temperature setting.
Press and hold
and
temperature unit. This action must be performed on the hidden touch controls.
Press
repeatedly to adjust the flame intensity setting. The display indicates LOW, MED
(medium), or HIGH.
!
NOTE: Allow 15 minutes of operation before adjusting the flame intensity.
The extractor fan boost clears any excess fogging that may appear in the fireplace.
Press and hold
for 5 seconds to turn on the extractor fan boost. Once finished, the
flame will resume on the low setting. This action must be performed on the hidden
touch controls.
Press
repeatedly to cycle the 8 different Ambient & flame color themes:
1 - Natural Flame
2 - Blue
3 - Violet
4 - Red
5 - Aquamarine
6 - Prism Mode - media and overhead lights cycle through colors
7 - Kaleidoscope Mode - media and overhead lights cycle through colors at
different rates.
8 - Custom (app required)
Press
repeatedly to cycle the top light brightness settings:
B1 - Brightness level 1
B2 - Brightness level 2
B3 - Brightness level 3
B4 - Brightness level 4
B5 - Brightness level 5
B6 - Pulsating effect
at the same time for 3 seconds to disable or enable the heat
is pressed, CD52 appears on the display.
at the same time for 3 seconds to change the displayed
www.dimplex.com
Publicité
