Publicité
Les langues disponibles
Les langues disponibles
Installation
Flame Baffles
The unit comes with breakable and slotted baffles to
create a customized flame. The unit can be operated with
or without the baffles. The baffles will create spacing to
customize a unique flame appearance.
Separate the breakable baffles by bending the strip until it
breaks into 4 single baffles. (Figure 15) The slotted baffles
are not breakable.
To insert the baffles, use a screwdriver to carefully pry open
the flame output slot on the top cover. (Figure 14) Install
the baffle by putting the side with the two tabs down, and
inserting it so that the lip on the top cover goes over the
baffle. (Figure 16)
Place the breakable baffles across the flame output slot as
desired to create the desired flame appearance.
Three slotted baffles are required to cover each flame
output slot.
Figure 15
Breakable
Baffles
Media Arrangement
1. Install media bed with the angled side of the slot
toward the back of the fireplace. (Figure 17)
2. Evenly disperse the small crystals to entirely cover the
media bed.
3. Place the driftwood pieces across the crystals.
4. Place the large and extra-large crystals as desired
over the smaller crystals and beside the driftwood.
!
NOTE: It is not recommended to position the
driftwood pieces across the flame output slot. If this
configuration is desired, use the provided baffles
to block the mist beneath the log(s) to prevent
condensation.
It is possible to use custom media ornaments to decorate
your fireplace. The custom media must fit easily without
scratching the glass or bowing the media bed, and must
not be composed of sand or liquid, which could interfere
with the safety of the fireplace.
Figure 14
Figure 16
Figure 17
Flame Output Slot
Slotted Baffles
17
Publicité
