Scubapro Aladin 2G Mode D'emploi page 84

All manuals and user guides at all-guides.com
1. Introduction
1. INTRODUCTION
Congratulations on purchasing Aladin 2G
and welcome to SCUBAPRO. From now
on you will enjoy the assistance of the most
extraordinary dive computer - equipped
with SCUBAPRO's
technology - while diving.
Aladin 2G enables you to use two different
gas mixtures during the same dive.
However, for an easy reading this manual
mainly refers to dives with a single gas
mixture. Information for diving with two gas
mixtures is marked with
summarized in special chapters.
We thank you for choosing Aladin 2G and
we hope you will enjoy safe dives in the
future! Further information on SCUBAPRO
dive computers and other products by
SCUBAPRO can be found on our web
page at www.scubapro.com.
To make this manual easier to read
we will use the term "Aladin 2G" as an
abbreviation for "SCUBAPRO Aladin 2G
diving computer" throughout this booklet.
Safety considerations
Dive computers provide
data; they, however, do not provide the
knowledge how this data should be
understood and applied. Dive computers
cannot replace common sense! You must
therefore carefully read and understand this
entire manual before using your Aladin 2G.
Important remarks concerning signal
words and symbols
This operating manual makes use of the
following icons to indicate especially impor-
tant comments:
)
NOTE:
Information and tips which are
important for optimal use of the
functions of Aladin 2G.
Danger!
WARNING
Indicates a potentially hazardous situation
which, if not avoided, could result in death or
serious injury.
6
The following symbols are used in the
operating manual:
->
most innovative
Audible signals
4 s
Instructions for manual input
or has been
Press left push button
Press and hold (1 second)
left push button
Press and hold (1 second) both
divers with
push buttons
Alternate displays
By pushing
scroll through alternate displays.
How to get back to the first display:
• scrolling with
• after 5 seconds: automatically if marked
with
• after 5 seconds: directly by pushing 1x
E.g. Max depth
> Temperature, Time
Time out after 5 seconds without
operation. Display switches back to
original indication.
Flashing display
Page reference e.g. ->10
Valid only for dives with 2 gas
mixtures
Audible attention signal
Audible alarm signal
Press right
push button
Press
and hold
(1 second)
right push
button
during the dive you can
through the displays
> Temperature
> Max depth
SCUBAPRO ALADIN 2G