Scubapro Aladin 2G Mode D'emploi page 143

All manuals and user guides at all-guides.com
Selecting the IrDA speed
The default setting is low. For faster
downloads you can set it to high, but not all
IrDA interfaces are compatible with high.
1. Confirm that you wish to change the
IrDA speed by pushing
or "hi" (high) starts to flash.
2. Switch with
high.
3. Confirm the setting with
Low: 9600 bits/second
High: max 57 600 bits/second
Switching the sound on and off
WARNING
If you turn off the sound, the buzzer is
effectively deactivated. You will have no
audible warnings (alarms and attention
messages)! Without audible warning you
could get into potentially hazardous situations,
which could result in death or serious injury.
You must assume full responsibility for turning
off the sound.
SCUBAPRO ALADIN 2G
1. Confirm that you wish to change the
setting by pushing
starts to flash.
2. Switch with
"off".
3. Confirm the setting with
have selected "off", "Code" and "000"
appear.
4. Set the first digit by pushing
Repeat point 4 for the next 2 digits. If you
entered the right code the sound will be
turned off.
Code: 313
)
NOTE:
. "Lo" (low)
Setting the "sound" to "off" applies
also to surface functions (mountain
between low and
alarm, wake-up alarm, change of
altitude range).
.
Showing the hardware electronic ID of
Aladin 2G
This number is needed when reporting
problems or for other maintenance related
issues.
11. Settings
. "On" or "off"
between "on" and
. If you
and
. Confirm with .
NO
ID Number
65