Scubapro Aladin 2G Mode D'emploi page 117

All manuals and user guides at all-guides.com
(Max depth
> MB level active
> No-stop time relative to L0
> Temperature
> (Max depth)...
)
NOTE:
Whereas the quantitative information relative to L0 can be seen by pressing the right
button, qualitative information is always visible on the display in form of the nitrogen
loading bar. In particular, when the L0 no-stop time is less than three minutes,
the nitrogen bar will flash ->27. This will help you avoid entering inadvertently into
decompression.
6.2.2 Display during level stop phase
Total ascent time
including level stops
DEPTH DIVE TIME
STOP
CNS O %
2
S
L
O
W
Level stop
Nitrogen
depth
loading bar
The deepest level
relative to LO
stop is displayed.
->27
->26
Level stop duration
The duration of a level stop
at a given level stop depth
is displayed.
(Max depth
> MB level active
> No-stop time or deco information relative to L0
> Temperature
> (Max depth)...
6.3 Preparation for a dive
with MB levels
6.3.1 Setting the MB level
To change the MB level Aladin 2G must be
in user mode (time of day display).
or until
SCUBAPRO ALADIN 2G
6. Diving with microbubble (MB) levels
>) Temperature
and time of day
Time
35.7m
MB no-stop phase
>) Temperature
and time of day
1. Push
MB levels
2. Confirm that you wish to change the
displayed MB level by pushing
3. Change MB level by pushing
.
4. Confirm the selected MB level with
Without
disappear after 3 minutes and your entries
will not be accepted.
Aladin 2G will display the
confirm that an MB level beyond L0 (L1-
L5) has been chosen. During the dive the
Total ascent time (14min)
3m/10ft
6m/20ft
Lowest level
9m/30ft
stop depth
3min
Level stop duration
Level stop phase
To complete the dive without cascading
to a lower MB level all requested
level stops must be observed.
or until the symbol for
appears.
.
or
confirmation the display will
symbol to
.
39