Logging Interval - Fronius Primo 3.0-1 Instructions De Service

6
7
8
The inverter starts copying the data.
'UPDATE' and the progress of storing the individual tests expressed in % are displayed un-
til all the data for all the electronic modules has been copied.
Once copying is complete, the inverter updates the electronic modules as required in se-
quence.
'UPDATE', the affected modules and the update progress in % are displayed.
The final step is for the inverter to update the display.
The display remains dark for approx. 1 minute while the monitoring and status LEDs flash.
Once the software update is complete, the inverter enters its startup phase before going
on to start feeding energy into the grid. The USB stick can be unplugged.
When the inverter software is updated, any custom settings that were configured in the
Setup menu are retained.

Logging interval

Activate / deactivate the logging function and specify a logging interval
Unit
Setting range
Factory setting
30 min.
20 min.
15 min.
10 min.
5 min.
No log
IMPORTANT! In order for the logging function to work correctly the time must be set cor-
rectly.
30
Press the 'Enter' key
Wait until the version currently installed on the inverter and the new software version
are displayed for comparison:
- 1st page: Recerbo software (LCD), key controller software (KEY), country setup
version (Set)
- 2nd page: Power stage set software
Press the 'Enter' key after each page
Minutes
30 min. / 20 min./ 15 min./ 10 min./ 5 min./ No log
30 min.
The logging interval is 30 minutes; every 30 minutes new log-
ging data will be saved on the USB stick.
The logging interval is 5 minutes; every 5 minutes new logging
data will be saved on the USB stick.
No data is saved