Fronius Primo Dummy; Explanation Of Footnotes; Applicable Standards And Guidelines - Fronius Primo 3.0-1 Instructions De Service

Fronius Primo
Nominal grid voltage
dummy
Mains voltage tolerance
Nominal frequency
Protection class
Dimensions h x w x d
Weight
Explanation of 1)
footnotes
2)
3)
4)
5)
6)
7)
Applicable stand- CE mark
ards and guide- The devices comply with all the requisite and relevant standards and guidelines that form
lines part of the relevant EU Directive, and are therefore permitted to display the CE mark.
Circuit to prevent stand-alone operation
The inverter has an approved circuit to prevent stand-alone operation.
Grid failure
The standard measurement and safety procedures integrated into the inverter ensure that
in the event of a grid failure, the feed-in of energy is immediately interrupted (e.g. switch-
off by the energy supplier or damage to lines).
54
The values quoted are default values; the inverter is configured specifically to meet
the needs of the country in question.
Depending on the country setup or device-specific settings
(ind. = inductive; cap. = capacitive)
PCC = interface to the public grid
Maximum current from the inverter to the solar module when an error occurs in the
inverter or when the insulation between the AC and DC side is defective
Guaranteed by the electrical configuration of the inverter
Current peak when switching on the inverter
Depending on the country setup
1 ~ NPE 230 V
1)
+10 / -5 %
1)
50 - 60 Hz
IP 65
645 x 431 x 204 mm
16.75 kg