The Setup Menu Items; Standby; Wifi Access Point - Fronius Primo 3.0-1 Instructions De Service

The Setup menu items

Standby

Manual activation / deactivation of Standby mode
-
-
-
-
-
-
Switching off Standby mode (manually switching off feeding energy into the grid):
1
2
'STANDBY' and 'ENTER' appear alternately on the display.
Standby mode is now active.
The Startup LED shows steady orange.
Resuming feeding energy into the grid:
'STANDBY' and 'ENTER' appear alternately on the display when in Standby mode.
1
The 'Standby' menu item is displayed.
At the same time, the inverter enters the startup phase.
The operating state LED shows steady green when feeding energy into the grid has been
resumed.
WiFi Access For activating / deactivating the WLAN access point (e.g. to set up system monitoring)
Point
Setting range
28
No energy is fed into the grid.
The Startup LED will show steady orange.
In Standby mode, no other menu item at menu level can be accessed or adjusted.
The automatic switchover into the 'NOW' display mode after 2 minutes of keyboard in-
activity does not occur.
Standby mode can only be terminated manually by pressing the 'Enter' key.
Feeding energy into the grid can be resumed at any time (deactivate 'Standby').
Select the 'Standby' item
Press the 'Enter' key
Press the 'Enter' key to resume feeding energy into the grid

WiFi Access Point

[stopped]
Activate WiFi AP?
WiFi Access Point
[active]
The SS-ID (SS) and password (PW) are displayed.
Deactivate WiFi AP?
WiFi Access Point
[not available]
Displayed if there is no system monitoring present on the invert-
er.
To activate the WLAN access point Press the 'Enter' key
To deactivate the WLAN access point Press the 'Enter'
key