System Monitoring; General; Using For The First Time - Fronius Primo 3.0-1 Instructions De Service

System monitoring

General

Where no special device model is present, the inverter is fitted with WLAN-compatible Fro-
nius Datamanager 2.0 system monitoring as standard.
Among other things, system monitoring includes the following functions:
-
-
-
-
-
-
-
-
-
-
Further information on Fronius Datamanager 2.0 can be found online in the Fronius Data-
manager 2.0 operating instructions.
Fronius Dataman- The Night Mode parameter under "Display Settings" in the Setup menu is preset to OFF in
ager during the the factory.
night or when the For this reason the Fronius Datamanager cannot be accessed during the night or when the
available DC volt- available DC voltage is insufficient.
age is insufficient
To nevertheless activate the Fronius Datamanager, switch the inverter off and on again at
the mains and press any key on the inverter display within 90 seconds.
See also the chapters on "The Setup menu items", "Display settings" (Night Mode).
Using for the first
time
When starting Fronius Datamanager 2.0 for the first time,
-
-
IMPORTANT! In order to establish a connection to Fronius Datamanager 2.0, the end de-
vice in question (e.g. laptop, tablet, etc.) must be set up as follows:
-
Own web page displaying current data and a wide range of different setting options
Option of connecting directly to Fronius Solar.web
Automatic sending of service messages by SMS or e-mail in the event of a fault
Internet connection via WLAN or LAN
Option of controlling the inverter by specifying power limit values, minimum or maxi-
mum running times or target running times
Control of the inverter via Modbus (tcp / rtu)
Assignment of control priorities
Control of the inverter by means of connected meters (Fronius Smart Meter or S0 me-
ter)
Control of the inverter via a ripple control signal recipient (e.g. specification of reactive
power or effective power)
Dynamic power reduction, taking self-consumption into account
NOTE! Starting the Fronius Datamanager 2.0 for the first time can be made sig-
nificantly easier with the aid of the Fronius Solar.web App.
The Fronius Solar.web App is available in the relevant App store.
the Fronius Datamanager 2.0 plug-in card must be installed in the inverter,
or
there must be a Fronius Datamanager Box 2.0 in the Fronius Solar Net ring.
"Obtain IP address automatically (DHCP)" must be activated.
17