Alliance Laundry Systems SWD448C Installation/Fonctionnement page 45

Washer Symptom
Too Many Soap Suds
Vibrates/Moves
Slightly
Is Noisy
Load is too Wet
Wrong Water
Temperature
Dryer Symptom
Won't Start
Won't Heat
Doesn't Dry Clothes
Satisfactorily
802703
• Laundry load may be oversudsing. Make sure you are using low sudsing, high efficiency
(HE) detergent.
• Make sure you are using the amount of detergent recommended on the detergent's label.
If using non-HE detergent, use only 1/2 of the detergent manufacturer's recommended
amount.
• Laundry load may be overloaded. Make sure you are using proper load sizes.
• Make sure washer is level. Uneven leveling can cause vibration.
• Make sure washer is installed on a solid, sturdy and level floor. The washer should not be
installed on carpeting, soft tile, a platform or other weakly supported structures.
• Make sure rubber feet are installed on all four leveling legs. Refer to Installation section,
Step 6.
• Make sure washer is level. Uneven leveling can cause vibration.
• Some sounds may be a part of normal operation for a frontload washer.
• Wash load may be unbalanced. The washer may have limited the spin speed to prevent
damage to the machine. Redistribute the load.
• Load is too small. Add items to make full load.
• Make sure that the controls are properly set.
• Check fill hoses. Make sure hot faucet hose is connected to hot mixing valve (indicated
with "H" on the valve bracket) and cold faucet is connected to cold mixing valve
(indicated with "C" on the valve bracket).
• Make sure laundry room water heater is adjusted properly.
• Insert coin(s) or card.
• For dryers equipped with a power cord, make sure the power cord is plugged all the way
into the electrical outlet.
• Make sure loading door is closed.
• Press START pad.
• Make sure the laundry room fuse(s) isn't blown or loose, or circuit breakers aren't open.
The dryer itself does not have an electrical fuse. An electric dryer has an electrical circuit
with two fuses.
• Check if motor overload protector has cycled. Wait 10 minutes and try again.
• Make sure the laundry room fuse(s) isn't blown or loose, or circuit breakers aren't open.
The dryer itself does not have an electrical fuse. An electric dryer has an electrical circuit
with two fuses.
• Make sure controls are in a HEAT setting.
• Gas dryer only – Make sure equipment and main gas line valves are turned on.
• Check exhaust duct to outside to see if it is kinked, blocked or needs cleaning.
• Check weather hood to make sure flapper moves freely, has not been pushed in or has not
been blocked.
• Check exhaust duct to outside to see if it is kinked, blocked or needs cleaning.
• Check weather hood to make sure flapper moves freely, has not been pushed in or has not
been blocked.
• Clean the lint filter.
• Make sure the load isn't too small. Small loads may not tumble properly or dry evenly.
• Check load being dried. Heavy items dried with lightweight items will not dry as quickly
as the rest of the load.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Possible Cause/Solution
Possible Cause/Solution
Troubleshooting
43