Alliance Laundry Systems SWD448C Installation/Fonctionnement page 44

Try these troubleshooting tips before making a service
call. You may save time and money!
Washer Symptom
Won't Fill
Won't Start
Won't Spin/Tumble
Stops/Pauses During
Cycle
Won't Drain
Water Leaks
42
Troubleshooting
• Make sure power cord is plugged all the way into the electrical outlet.
• Make sure hot and cold water faucets are turned on.
• Make sure that the fill hoses are not kinked or twisted.
• Press START keypad.
• Make sure that the controls are properly set.
• Make sure that the loading door is closed tightly.
• Check the laundry room fuse or circuit breaker.
• Clean the screens in the water mixing valve and the filter screens located at the faucet end
of the fill hoses.
• Make sure loading door is closed tightly.
• Press START keypad.
• Make sure power cord is plugged all the way into the electrical outlet.
• Check the laundry room fuse or circuit breaker.
• Insert coin(s) or card.
• Make sure door latch is properly adjusted, relative to door lock.
• Make sure loading door is closed tightly.
• Press START keypad.
• Make sure power cord is plugged all the way into the electrical outlet.
• Make sure controls are properly set.
• Check the laundry room fuse or circuit breaker.
• Broken drive belt. Call the service person.
• Foreign object trap in pump may be clogged. Clean the trap. Refer to
Maintenance section.
• Pauses are part of the washer's normal operation.
• Wash load may be unbalanced. Washer will stop and then restart spin automatically.
• Check the laundry room fuse or circuit breaker.
• Make sure drain hose is not kinked or twisted.
• Make sure drain hose is not clogged.
• Make sure drain receptacle is not clogged.
• Refer to the Installation section to make sure that the drain hose has been properly
installed.
• Foreign object trap in pump may be clogged. Clean the trap. Refer to Maintenance
section.
• Check that fill hoses are properly installed on the faucets and the washer's water mixing
valve.
• Check the condition of the fill hoses. Replace fill hoses every five years.
• Check the condition of the rubber door gasket for tears or holes.
• Make sure drain receptacle is not clogged.
• Check building plumbing.
• Laundry load may be oversudsing or overloaded. Make sure you are using low-sudsing,
high efficiency (HE) detergent and proper load sizes.
• Make sure outside perimeter of the door glass where seal contacts glass is clean.
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Possible Cause/Solution
802703