Alliance Laundry Systems SWD448C Installation/Fonctionnement page 29

Step 3: Add Laundry Supplies
Open dispenser drawer. Measure and add low sudsing,
high efficiency (HE) detergent (1), bleach (2) and
fabric softener (3) to the dispenser drawer. Refer to
Figure 23. Close dispenser drawer.
IMPORTANT: If using non-HE detergent, avoid
oversudsing by using 1/2 of the detergent
manufacturer's recommended amount.
CAUTION
Dispenser drawer requires a special tool for
removal. Contact a service person if
removal is necessary.
1 Detergent
2 Bleach
3 Fabric Softener
Figure 23
802703
W236
3
1
2
SWD814N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 4: Determine Proper Controls for
Washer
The direction of the arrow indicates which controls are
for the washer.
Figure 24
Step 5: Set Fabric Selector and Wash
Temperature (cycles vary by model)
Push keypad for cycle. Light indicates selection.
NOTE: Changes can be made to Fabric Selector
setting up until the first fill is complete.
Figure 25
Operation
SWD960N
SWD976N
SWD976N
27