Alliance Laundry Systems SWD448C Installation/Fonctionnement page 10

Installation
Before You Start
Supplies
For most installations, the basic supplies you will need
are:
1
4
3
7
1 Safety Glasses
2 Wood Block
3 Wrench
4 Screwdriver
5 Level
6 5/16 Inch Socket Wrench
7 Duct Tape
8 Teflon Tape (Gas Models)
Figure 1
8
2
5
6
8
SWD851N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
NOTE: A 20.32 cm (8 inch) coin drawer is required
for coin operated models.
WARNING
Any disassembly requiring the use of
tools must be performed by a suitably
qualified service person.
NOTE: If the unit is delivered on a cold day (below
freezing), or is stored in an unheated room or area
during the cold months, do not attempt to operate
it until the unit has had a chance to warm up.
NOTE: Some moisture in the wash drum is normal.
Water is used during testing at the manufacturer.
W299
802703