Alliance Laundry Systems SWD448C Installation/Fonctionnement page 32

Operation
Step 3: Add Laundry Supplies
Open dispenser drawer. Measure and add low sudsing,
high efficiency (HE) detergent (1), bleach (2) and
fabric softener (3) to the dispenser drawer. Refer to
Figure 31. Close dispenser drawer.
IMPORTANT: If using non-HE detergent, avoid
oversudsing by using 1/2 of the detergent
manufacturer's recommended amount.
CAUTION
Dispenser drawer requires a special tool for
removal. Contact a service person if
removal is necessary.
1 Detergent
2 Bleach
3 Fabric Softener
Figure 31
30
W236
3
1
2
SWD817N
© Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Step 4: Determine Proper Controls for
Washer
The direction of the arrow indicates which controls are
for the washer.
Figure 32
Step 5: Set Fabric Selector
Push keypad for NORMAL, PERM PRESS or
DELICATES cycle. Light indicates selection.
NOTE: Changes can be made to Fabric Selector
setting up until the first fill is complete.
PERM
NORMAL
PRESS
HOT
WARM
Figure 33
SWD960N
DELICATES
START
COLD
H205I
H205I
802703