Alliance Laundry Systems SWD448C Installation/Fonctionnement page 13

Step 3: Connect Drain Hose to Drain
Receptacle
Remove the drain hose from its shipping position on
the rear of the washer by removing the shipping tape.
IMPORTANT: Drain receptacle must be capable of
handling a minimum of 3.5 cm (1.375 inch) outside
diameter drain hose.
802703 © Copyright, Alliance Laundry Systems LLC – DO NOT COPY or TRANSMIT
Standpipe Installation
Place the drain hose into the standpipe.
Remove the beaded strap from accessories bag and
place around standpipe and drain hose and tighten
strap to hold hose to standpipe. This will prevent the
drain hose from dislodging from drain receptacle
during use.
1
61 TO 91.44 cm
(24 TO 36 in.)
RECOMMENDED
HEIGHT
2
3
1 Drain Hose
2 Beaded Tie-Down Strap
3 Standpipe – 5.08 cm (2 in.) or 4 cm (1.5 in.)
Figure 5
Installation
SWD628N
SWD628N
11