Publicité
Les langues disponibles
Les langues disponibles
Press the key corresponding to the dose to be
programmed (key T1 for example) within 30 seconds
(programming time-out). The LED light of the dose
being set keeps switched on together with the T3 key
of the keypad of the group to be set. During this stage
and for the entire coffee dose programming time
duration, the solenoid valve and the pump are
activated.
If no dose key is pressed
within 30 seconds, it will
automatically escape from
programming mode.
After pressing the T1 key, the brewing starts. After
reaching the desired coffee dose, press the T1 key
again to stop brewing the coffee dose. This way the
new value is saved by the pulses of the dose. Both the
solenoid valve and the pump are deactivated thereby
suspending product brewing. The LED relating to the
programmed key turns off.
To carry out a new programming of the other coffee
doses T2-T4-T5-T6 (if the programming time-out of
30 seconds has not been exceeded), it is sufficient to
repeat the same sequence of operations carried out
for the T1 key.
Press the T3 key again to immediately exit the
programming stage.
During the programming of
a group the operation of
the other groups as well as
tea
brewing
deactivated.
In order to program other groups, press the
programming button and repeat the same sequence of
operations previously carried out.
English
are
29
Publicité
