Gaggia Milano La Giusta Mode D'emploi Et D'entretien page 20

English
Connect the power cable (E) to the electric line using a
plug, or in the case of fixed installation, using a
multi-polar switch (D) for mains separation, with a
contact distance of at least 3 mm.
Please refer to the technical manual for voltage change.
The yellow-green coloured
cable MUST be connected
to the room's earthing
system.
Depending
regulations in force in the
Country where the machine
is being used, the cable
connecting to the power
supply has to be pre-set or
equipped with an all-pole
switch (with a minimum
contact opening of 3 mm),
or with a plug complying
with the same regulations.
It is recommended
install a residual current
device (RCD) with a rated
residual
exceeding 30 mA.
20
on the
to
current not
If the power
damaged, it
replaced
manufacturer, its service
centre or by adequately
qualified personnel
order to avoid any risks.
cord is
must be
by the
in