Publicité
Les langues disponibles
Les langues disponibles
Remark: Auxiliary protection is always active, even if there are no errors and the spa is
Remark:
Remark:
Remark:
stopped.
problem. Check the water level in the spa. Top it up if necessary. If the level is correct,
problem.
problem.
problem.
check that the pumps have been initiated. If the problem occurs frequently, contact your
spa dealer or repairer.
This message is displayed during the fifth occurrence of the previous message
(HL, HFL). It indicates a persistent water pressure problem
the other functions operate normally. Run a power on/off cycle for the spa to re-start
the heating. Bath heating does not reinitialize automatically.
This message indicates that there is not enough water in the heating device. The
spa stops for 15 minutes. This may mean a poor pressure
bubbles in the heating device.
bubbles
bubbles
bubbles
It is then necessary to check the water level in the spa. Top it up if necessary. If the level
is correct, check that the pumps have been initiated. Press any button to re-initialize the
spa, otherwise this message will be redisplayed automatically in the next 15 minutes.
This message is displayed during the third occurrence (
does not reinitialize for 15 minutes. Press any button to manually re-start it.
This means that an important temperature difference has been
detected between the 2 sensors. This may indicate a water pressure
a persistent water pressure problem. The heating is stopped while
a persistent water pressure problem
a persistent water pressure problem
poor pressure
poor pressure or the presence of air
poor pressure
33
a water pressure
a water pressure
a water pressure
presence of air
presence of air
presence of air
dry
). The spa stops and
Publicité
