Publicité
Les langues disponibles
Les langues disponibles
Pump jet 1 is a two-speed pump. In low speed, it ensures continuous filtration of your
spa. (refer to the" filtration cycle programming" section). In high speed, it provides the
massage pump function.
When the filtration cycle is not active, an initial press on the "jets 1" key will start low
speed, a second press delivers massage speed.
When the filtration cycle is active, it is not possible to deactivate low speed. However,
you can still activate and deactivate the massage function.
If you do not stop pump 1, it will stop automatically after 15 minutes operation at high
speed or after 2 hours operation at low speed.
One press on the "Jets 2" key activates pump 2. This pump only has one speed.
A second press on the "Jets 2" key stops pump 2. If you do not stop it manually, the
second pump will stop automatically after 15 minutes operation.
Your spa is equipped with a cascade. The cascade is linked to the Jets 2 circuit (pump 2)
of your spa. To activate the cascade you must first start pump 2 by pressing the "Jets 2"
key, then adjusting the pressure with the "Cascade control" valve.
Your spa is equipped with a blower linked to a specific circuit dedicated to injecting
bubbles of air into the bath. This blower system, integrated in the spa, has 11 air jets
permitting the formation of relaxing and massaging bubbles.
Press the "Blower" key to activate or deactivate it. If you do not deactivate the blower
manually, it will stop automatically after 15 minutes of operation.
7.6.1. Pump 1
7.6.2. Pump 2
7.6.3. Cascade
7.6.4. Activation of the blower (optional)
23
Publicité
