AQUALUX Orchidee Manuel D'instructions page 57

keys. Once the filtration duration has been chosen, press the "jets 1" key to record the
selection and exit programming mode.
Please note that after reprogramming the filtration cycle duration of your spa, this
programming will only become effective at the next cycle.
7.4. Adjustment of the set temperature
The command keypad screen displays, in standard operating mode, the actual
temperature of the water in the bath (after at least 2 minutes of pump operation). By
pressing the "High" and "Low" keys, you can display the set temperature, which you can
increase or decrease by 0.5°C at each press. The set temperature corresponds to the
temperature the bath will reach at the end of the heating cycles. You can freely fix the
set temperature, from 26 to 40°C. However, it is not recommended to bathe for a long
time in water exceeding 38°C.
In standard mode, heating starts if the water temperature is less than 1°C below the set
temperature. Pump 1 operates without stopping until the set temperature is reached.
When heating is operating, the LED of the icon lights up.
Reminder: in 16A operation, your spa operates with a shedding system, which means
that when you activate the massage pumps, the heater cuts off. This cut-off does not
affect filtration (pump 1 low speed).
19