Barbecook SIESTA 310 Mode D'emploi page 13

MAN_GAS_SIESTA_310_310_CREME_BBC_151001_B.book Page 13 Thursday, October 1, 2015 9:14 AM
11.2 Cleaning the bowl
We recommend cleaning the bowl after each use. To do so,
remove the bottom trays from the bowl and clean them properly.
You can:
• Put the trays in your dishwasher. This might, however, not
remove all encrustations and greases.
• Clean the trays with the Barbecook cleaner. Use it the same
way you do on the grills.
11.3 Cleaning the burners and venturis
11.3.1 W
HY CLEAN THE BURNERS AND VENTURIS
Spiders and insects can make webs and nests in the burners and
venturis. This may block the gas supply to the burners. As a
result:
• You cannot light the burners. If you manage to light them
anyway, they will only produce smoky and yellow flames.
• The gas can start burning outside the venturis, at the control
knobs. These fires are called flash-backs and can result in
serious injuries and material damage.
0
Damages caused by blocked burners and venturis are
regarded as inadequate maintenance and are not
covered by the warranty.
11.3.2 W
HEN CLEAN THE BURNERS AND VENTURIS
You have to clean the burners and venturis of your appliance:
• Before the first use after a long period of non-use.
• At least twice a year, of which once at the beginning of the
season.
11.3.3 T
O CLEAN THE BURNERS AND VENTURIS
1 Remove the burners from the appliance as shown on the
illustrations. If you notice that a burner is damaged, you have
to replace it.
A
B
?
2 Clean the burners and venturis with a small brush or a
homemade pipe cleaner (an unfolded paperclip, a pipe
brush...).
3 Put the burners back. Make sure to place the venturis over
the openings of the gas valves.
11.4 Maintaining enamel, stainless steel
and powder coated parts
The appliance is composed of enamelled, stainless steel and
?
powder coated parts. Each material has to be maintained
differently:
Material
•
Enamel
•
•
•
Stainless steel
•
•
•
•
Powder
coated
•
1
To prevent formation of rust on stainless steel, avoid
contact with chlorine, salt and iron. We recommend not
using the appliance near the coast, near railways or near
swimming pools.
1
Damages caused by not following these instructions are
regarded as inadequate maintenance and are not
covered by the warranty.
www.barbecook.com
How to maintain this material
Do not use sharp objects and do not knock
against a hard surface.
Avoid contact with cold liquids while still hot.
You can use metal sponges and abrasive
detergents.
Do not use aggressive, abrasive or metal
detergents.
Use soft detergents and let them act on the
steel.
Use a soft sponge or cloth.
Rinse thoroughly after cleaning and dry well
before storing.
Do not use sharp objects. Use soft detergents
and a soft sponge or cloth.
Rinse thoroughly after cleaning and dry well
before storing.
13