Safeguards - Animo M200W Mode D'emploi

Masquer les pouces Voir aussi pour M200W:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

• Wash your hands thoroughly after descaling the appliance.
• Always have repairs carried out by a qualified service engineer.
• The plug must be taken out of the socket if the appliance has to be opened for cleaning
or repairs.
The manufacturer cannot be held liable for losses caused as a result of failure to observe these
safety instructions.

Safeguards

The appliance is fitted with the following safeguards:
Dry-boil protection (20+21)
This appliance is equipped with two dry-boil protectors on the back. The protector on the left
(21) is that of the water boiler. On the right (20) is the one for the coffeemaker.
These protectors are switched off if the heating elements get overheated as a result of a fault.
This appliance is equiped with a dry-boil protection. This protection triggers if the heating
element overheats owing to a fault. Once the fault has been resolved, the dry-boil
protection can be reset at the back of the appliance. The most common cause of the dry-boil
protection being triggered is not descaling the heating system in time.
If the heating system does not switch back on, proceed as follows:
1.
Allow the appliance to cool down.
2.
Unscrew the protective cap.
3.
Press the button which is now visible and firmly screw the protective cap back on.
If the dry-boil protection triggers owing to increased scale deposits, descale the appliance.
See chapter 6.2 Consult your dealer if the fault was caused by a problem other than the dry-boil
protection being triggered.
On/off switch (1+13)
Each appliance is switched on/off separately using the on/off switch (1+13). Remember that the
appliance can still be live after switching it off! For this reason you should always remove the
plug from the socket to render the appliance voltage-free.
Start/stop button (5.5)
The coffee making process can be interrupted at any point using the start/stop button
located on the control panel.
Jug detector (10)
This appliance is fitted with a jug detector that operates the leak stop under the filter.
This jug detector also ensures that the appliance only makes coffee if there is a jug under the
filter. If the jug is removed during the coffee brewing process, the process will be interrupted
and the filter will stop leaking.
Animo
26

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

M202wMt200wMt202w

Table des Matières