Troubleshooting - Animo M200W Mode D'emploi

7.

Troubleshooting

WARNING
• Have all repairs to the electrical system performed by a qualified service technician.
If your appliance is not functioning correctly, use the troubleshooting guide below to see
whether you can resolve the problem yourself. If not, please contact your dealer.
Troubleshooting guide coffee making selection
Symptom:
The appliance is not working
and the lamps in the switch
are not lighting up.
The brewing process indicator
light (5.3) is flickering, no
water is getting into the filter.
The brewing process indicator
light (5.3) is on, but no water is
getting into the filter.
The descale indicator light
(5.2) has come on.
The descale indicator light
(5.2) remains on after
descaling the appliance.
Steam is coming from the filter.
Coffee is dripping out of the
filter when there is no jug
under it.
The coffee is too strong.
The coffee is too weak.
Animo
Possible cause:
The fuse in the fuse box has
been triggered, the group is
loaded too heavily.
The jug indicator is not regis-
tering a jug. There is no jug
under the filtert.
The dry-boil protection has
been triggered.
The scale deposits in the
heating system exceed the set
limit.
The appliance has not yet been
reset.
The appliance was not
descaled when indicated by the
descale indicator light or the
wrong water setting has been
applied.
The leak stop valve on the out-
let of the filter is soiled or
damaged.
Too much coffee has been
placed in the filter.
Not enough coffee has been
placed in the filter.
The water distributor is soiled,
so that the coffee is not being
completely drenched.
40
Action:
Replace the fuse or reset it.
Connect the appliance to a
separate group.
Position a jug, use the correct
jug.
Reset the dry-boil protection.
See page 26. Safeguards;
dry-boil protection.
Descale the appliance, see
chapter 6.2 Descaling.
Press the programme button
(5.4) for 6 seconds. The light
will go out. See chapter 3.2.7
Resetting the descaling
indicator light.
Descale the appliance, see
chapter 6.2 Descaling
See chapter 3.2.6 Setting the
descaling indicator.
Clean the filter and check the
leak stop valve for damage.
Reduce the amount of coffee.
Increase the amount of coffee.
Unscrew the water distributor
and clean it