Making Coffee; Termination Of The Brewing Process - Animo M200W Mode D'emploi

4.3

Making coffee

1. Place a sheet of basket filter paper containing the desired amount of coffee (fast filter
type) in the basket filter. See the table above for the amount of coffee required. A level
coffee measure is approximately 80 grams.
2. Slide the basket filter (3) into the appliance.
3. Place the jug, with the lid on it, under the filter. NB! For the MT200 model, leave the lid
of the thermos jug with pump open, and leave the riser tube in the jug.
4. Switch on the coffeemaker using the on/off switch (1). The light in the switch will come
on and the lower heating plate will switch on.
5. Select the desired amount in the display (5.1) using the selection button (5.4).
6. Press the start/stop button, the green indicator light (5.3) will switch on and the
appliance will start making coffee. While the appliance is making coffee the display
(5.1) will alternately show the selected quantity and the amount of coffee that has
already been made.
7. Once the coffee making process has been completed the green indicator light (5.3) will
go out and an audible signal will sound three times, indicating that the coffee is ready.
The jug can be removed before the filter has been completely emptied, but there will be
no audible signal if this is done. Once the filter has been cleaned you can immediately
carry on making coffee.
8. Pour out the coffee or place the jug on the top hot plate (6)(except for the MT models).
The top hot plate is switched on separately using the on/off switch (2). Always switch off
the extra hot plate when it is not being used.
9. After cleaning the basket filter the appliance can immediately be used to make the next
serving of coffee.
4.4

Termination of the brewing process?

The process can be stopped at any moment.
• By once again pressing the start/stop button (5.5). If the start/stop button is then pressed
again, the process will start again from the beginning! To avoid aborting an interrupted
coffee making process, use the selection button (5.4) to select a smaller quantity of coffee
so that the amount already made does not overflow.
• Remove the jug from under the filter. The jug detector (9) will temporarily interrupt the
coffee making process and the leak stop will prevent the filter (3) from dripping.
The green indicator light (5.3) will flicker, and a short audible signal will sound. When the
jug is replaced under the filter the coffee brewing process resumes and will be completed.
Animo
34