MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 9

MOUNTING CONSIDERATIONS
It is recommended that the motor be mounted as close to the centerline of the boat as
possible. Make sure the area under the mounting location is clear to drill holes and install
nuts and washers. Make sure the motor rest is positioned far enough beyond the edge of
the boat. The motor must not encounter any obstructions as it is lowered into the water
or raised into the boat when stowed and deployed. Consider a quick release or adapter
bracket with the installation of your motor. To view a list of accessories, please visit
minnkotamotors.com.
TOOLS AND RESOURCES REQUIRED
• #3 Phillips Screw Driver
• Drill
• 9/32" Drill Bit
INSTALLATION
INSTALLING THE RIPTIDE TERROVA
1
a. Place the mount on an elevated, level surface such
as a workbench or the tailgate of a pickup. The
motor, as removed from the box, should be in the
stowed position.
b. Remove the four sideplate screws using a #3 Phillips
screwdriver. Two of these screws will be located on
each side of the mount.
This motor weighs approximately 65lbs.
NOTICE:
Minn Kota recommends having a second person help
with the installation.
©2022 Johnson Outdoors Marine Electronics, Inc.
INSTALLING THE RIPTIDE TERROVA
• 7/16" Box End Wrench
• A second person to help with the installation
1b
Deployed Deployed
View accessories
available for your
trolling motor at
minnkotamotors.com.
Sideplate Screw Sideplate Screw
Stowed Stowed
minnkotamotors.com | 9