MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 33

3
f. Reassemble the remote. Begin by removing the
board from the front of the Remote Case. This is the
same board that holds the battery. Leave the Keypad
in place on the front of the remote.
g. Note that the Alignment Peg in the back of Remote
Case must line up with the corresponding alignment
hole in the circuit board. Place the board with the
battery facing down on the back of the Remote Case.
4
h. Position the back of the Remote Case so that the
Alignment Peg is towards the top when the remote
is laying on a flat surface. Position the front of the
Remote Case so the keypad and the curved buttons
are towards the bottom when the remote is laying on
a flat surface.
i. Keep the back of the Remote Case flat. Place the
front of the Remote Case, with the Keypad in place,
on the back of the Remote Case. Make sure the Case
is seated.
5
j. Reinstall the four case screws and tighten them
as required.
©2022 Johnson Outdoors Marine Electronics, Inc.
REPLACING THE BATTERY
3f
Remote Remote
Case Front Case Front
Battery Battery
3g
Battery Battery
Alignment Alignment
Peg Peg
Retaining Fingers Retaining Fingers
Remote Remote
Case Front Case Front
Alignment Alignment
Keypad Keypad
Retaining Retaining
Fingers Fingers
Remote Remote
Case Back Case Back
Peg Peg
Circuit Circuit
Board Board
Screws Screws
minnkotamotors.com | 33
Remote Remote
Case Case
Back Back