MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 31

ADDING/REMOVING REMOTES
The CoPilot remote came from the factory already "Learned" by the CoPilot receiver. Any additional remotes must be "Learned" by the
receiver. The receiver stores all "Learned" information even when the motor is disconnected from a power source.
To "Learn" Remotes
Your receiver may learn up to ten remotes. Any additional remotes can be "Learned" using the following steps. This will also work to
"Learn" any remote if all remotes are erased from the receiver.
1
a. Using a small blunt object such as a pen or
screwdriver, press and hold the Learn Button
located on the side of the receiver.
b. The receiver will emit a continuous tone.
2
c. Press any button on the remote.
d. The receiver will beep 4 times confirming that it has
"Learned" the remote successfully.
"Learning" the same remote will not
NOTICE:
overwrite previously "Learned" remotes. If the
receiver has "Learned" ten remotes, "Learning" an
eleventh remote will overwrite the first remote.
To Erase All Remotes from the Receiver
1
a. Remove power from the CoPilot receiver by
disconnecting the Power Cables, or by making sure
that the breaker, if equipped, is "off."
©2022 Johnson Outdoors Marine Electronics, Inc.
ADDING/REMOVING REMOTES
Right Sideplate Right Sideplate
Learn Button Learn Button
Power Cables Power Cables
minnkotamotors.com | 31