MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 12

INSTALLING THE RIPTIDE TERROVA
7
ITEM(S) NEEDED
#1 x 6
k. Put a 1/4-20 x 3 1/2" (Item #1) screw in each of the
drilled locations. The screw should pass through
the Base Extrusion and the boat deck. If the rubber
washers (Item #4) are used, they should sit between
the Base Extrusion and boat deck. Make sure to
secure the motor with screws on each side of the
Base Extrusion.
l. Place a Flat Washer (Item #2) and then a Nylock Nut
(Item #3) at the end of each screw as shown and
secure. Make sure all hardware is secure.
To prevent seizing of the stainless steel
NOTICE:
hardware, do not use high speed installation tools.
Wetting the screws or applying an anti-seize may help
prevent seizing.
8
m. Replace the Right Sideplate.
n. Swing the Left Sideplate back into its correct
position on the Base Extrusion.
8m
12 | minnkotamotors.com
#2 x 6 #3 x 6
Right Sideplate Right Sideplate
#4 x 6
Screw Screw
Boat Boat
Deck Deck
Rubber Rubber
Washer Washer
Flat Washer Flat Washer
Nylock Nut Nylock Nut
8n
Base Extrusion Base Extrusion
Left Sideplate Left Sideplate
©2022 Johnson Outdoors Marine Electronics, Inc.