MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 13

9
o. Replace the four sideplate screws using a #3 or #2
Phillips screwdriver. Two of these screws will be
located on each side of the mount.
ROUTING THE i-PILOT LINK CABLE
Your trolling motor may be pre-installed with either i-Pilot or i-Pilot Link. To learn more about the GPS capabilities available with your
i-Pilot or i-Pilot Link navigation system, please refer to the corresponding Owner's Manual by visiting minnkotamotors.com.
The i-Pilot Link features require a cable to be connected to an output device. This connection is present on the trolling motor below the
Control Head, if installed. The i-Pilot system does not need an external wired connection. If only one connection is present, your motor
is equipped with the i-Pilot Link system. If no connections are present, your motor may or may not be installed with i-Pilot. Please follow
the Minn Kota recommendations on routing the cables to optimize mobility and maximize functionality. The routing will be the same
regardless of the number of cables present. Use the following instructions to properly route cables.
Cables are shielded to minimize interference. To protect this
shielding the cables should not be pulled tight against sharp
angles or hard objects. If using cable ties, do not over-tighten.
Any excess cable should be bundled in a loose loop of no less than
4" in diameter.
To minimize trolling motor interference, ensure that the fish finder
and trolling motor are powered by separate batteries. Please refer
to the Battery & Wiring Installation and Motor Wiring Diagram
sections of this manual for correct rigging instructions.
©2022 Johnson Outdoors Marine Electronics, Inc.
ROUTING THE i-PILOT LINK CABLE
i-Pilot Link i-Pilot Link
Cable Cable
Locking Collar Locking Collar
Sideplate Screw Sideplate Screw
Eight Pin Eight Pin
Connector Connector
i-Pilot Link Cable i-Pilot Link Cable
from Control Head from Control Head
minnkotamotors.com | 13