MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 36

SERVICE & MAINTAINANCE
TROUBLESHOOTING THE COPILOT
Cause
Remote is not transmitting.
When receiver is powered up, it
sounds a beep pattern (1 long beep,
2 short beeps, pause, repeat).
The prop is not turning but the Prop
ON audio pattern is still going.
FOR FURTHER TROUBLESHOOTING AND REPAIR
We offer several options to help you troubleshoot and/or repair your product. Please read through the options listed below.
Buy Parts Online
You can buy parts online directly from our website at minnkotamotors.com. From screws to sideplates, you can order replacement
parts for your Minn Kota products.
Frequently Asked Questions
Find answers to general inquiries, battery and rigging installation, and networking scenarios. We have FAQs available on our
website at minnkotamotors.com
Call Us (for U.S. and Canada)
Our consumer service representatives are available Monday – Friday between 7:00 a.m. – 4:30 p.m. CST
at 800-227-6433. If you are calling to order parts, please have the 11-character serial number from your
product, specific part numbers, and credit card information available. This will help expedite your call and
allow us to provide you with the best consumer service possible. You can reference the parts list located in
your manual to identify the specific part numbers.
Contact Us
You can contact our consumer service department with questions regarding your Minn Kota products.
To inquire, visit minnkotamotors.com.
Authorized Service Centers
Minn Kota has over 800 authorized service centers in the United States and Canada where you can
purchase parts or get your products repaired. Please visit our website to locate a service center in your area.
36 | minnkotamotors.com
Effect
The battery is discharged.
Receiver may not have "learned" the remote.
With the foot pedal connected, the MOM-CON switch is
in the CON position. An audio response will be heard if a
button is pressed with the foot pedal in the CON position.
If remote has been taken apart, the keypad and top case
may have been installed backwards.
The foot pedal Momentary/Constant Switch is in the
CON position.
Prop Speed is set at "0".
The Prop ON audio pattern occurs only in Audio Mode 3
to help answer all of your Minn Kota questions.
Solution
Replace battery.
Remote needs to be learned. See the Adding/Removing
Remotes section of this manual to learn the remote.
The foot pedal switch must be placed in Momentary Mode
(MOM). The receiver will not accept any commands from
the remote with the switch in the Constant Mode (CON)
position.
Take remote apart. See the Replacing the Battery section
of this manual and reinstall case halves with the proper
orientation.
The foot pedal switch must be placed in the MOM
position. The beeping sound will continue until the switch
is placed in the MOM position.
Increase the Prop Speed above "0"
Switch Audio Mode to either Audio 1 or 2. See the Audio
Modes section of this manual.
©2022 Johnson Outdoors Marine Electronics, Inc.
Scan to visit
Minn Kota
service online.