MINN KOTA RIPTIDE TERROVA Manuel Du Propriétaire page 32

REPLACING THE BATTERY
2
b. Press and hold the Learn Button and power up the
CoPilot receiver by reconnecting the Power Cables, or
by making sure that the breaker, if equipped, is "on."
c. Continue to hold the Learn Button down for 10
seconds. During this time the receiver audio will emit
a warble sound, slowly transition to a constant beep
and then shut off.
d. Release the Learn Button and the receiver will
reboot. The receiver will emit a 2 second long beep
indicating memory is empty. This audio pattern
will occur each time the receiver powers up until a
remote is "Learned."
REPLACING THE BATTERY
1
a. Temporarily ground yourself by touching a grounded
metal object in order to discharge any static
electricity in your body.
The replacement battery must be a model
NOTICE:
CR2032 coin cell type. It is strongly recommended that
a name brand battery is used.
b. Remove the four screws on the bottom of the
Remote Case.
c. Separate the case halves to access the circuit board.
2
d. To remove the Battery, place the tip of a finger or
thumb under the exposed edge of the Battery and
pry it upwards.
e. Install the new battery with the positive (+) side of
the Battery facing up and away from the Circuit
Board. Ensure Battery is snapped securely in place.
WARNING
THIS PRODUCT CONTAINS A BUTTON BATTERY. If swallowed,
a lithium button battery can cause severe or fatal injuries
within two hours. Keep batteries out of reach of children. If you
think batteries may have been swallowed or placed inside any
part of the body, seek immediate medical attention.
32 | minnkotamotors.com
Right Sideplate Right Sideplate
Learn Button Learn Button
Remote Remote
Case Front Case Front
Battery Battery
©2022 Johnson Outdoors Marine Electronics, Inc.
Screws Screws
Circuit Board Circuit Board
Retaining Retaining
Fingers Fingers