Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
If INIT via AIRFLOW: TAC5 F will determine automatically the pressure value
16
INIT F1
0000 m³h
17
INIT F2
0000 m³h
INIT F1
18
xx,x V
INIT F1
xxxx m³h
INIT F2
19
xx,x V
INIT F2
xxxx m³h
RESET
20
ALARMS?
END SETUP
21
If INIT via PRESSURE: enter the pressure or voltage value
16
REF F1?
xx,x V
17
REF F2?
xx,x V
RESET
18
ALARMS?
END SETUP
19
3.1.2.3.2 Wiring Diagrams
3.1.2.3.2.1
Wiring to 1 circuit with 1 fan or 2 fans whose airflows are dependant
Enter nominal airflow to determine corresponding pressure CPs for fan 1.
If # VENT=F1 + F2 and F2=%F1 = no. Enter nominal airflow to determine
corresponding pressure CPs for fan 2.
Initialisation of the reference pressure on fan 1 busy. After 1 minute the CB will
memorize the value of the measured static pressure on fan 1 once the INIT airflow is
reached.
Display of instant value of airflow and voltage while initializing.
If # VENT=F1 + F2 and F2=%F1 = no. Initialisation of the reference pressure on fan
2 busy. After 1 minute the CB will memorize the value of the measured static
pressure on fan 2 once the INIT airflow is reached.
Display of instant value of airflow and voltage while initializing.
Possibility to reset the alarms. Y or N?
The setup is then completed.
Enter nominal voltage value for Fan1.
If # VENT=F1 + F2 and F2=%F1 = no. Enter nominal voltage value for Fan2.
Possibility to reset the alarms. Y or N?
The setup is then completed.
K1 closed soft start
K1 open soft stop
K2 0-10V signal, maximum impedance
allowed: 1500 Ω
K1+K3 closed % on K3 activated
K3 open % on K3 inactive
Caution: use gold-plated contacts only.
19
Publicité
Table des Matières
