Swegon TAC5F Manuel D'installation page 11

If INIT Pa REF is set to Yes
23 m³h INIT
24 Pa REF
INIT
xxxx m³h
xxxx Pa
25 RESET
ALARMS?
26 END SETUP
3.1.2.1.2 Wiring Diagrams
3.1.2.1.2.1 Wiring 1 circuit to 3 external contacts
If Y is selected, enter nominal airflow at which you wish to initialize the reference
pressure. (same airflow for fan 1 and fan 2)
Initializing the reference pressure...
After +/-1 minute, the system will memorize the calculated pressures value of the
fans as the reference pressure. While initializing the airflow and pressure on F1 is
displayed.
Possibility to reset the alarms. Y or N?
The setup is then completed.
K1 closed  airflow m
K2 closed  airflow m
K3 closed  airflow m
K1/K2/K3 open  soft stop
Caution K1/K2/K3: Use gold-plated contacts only
3
h K1
3
h K2
3
h K3
13