Swegon TAC5F Manuel D'installation page 14

if # VENT=F1 : 1 fan only
14
% on K3?
15 CONFIG
TIME? N
16 TIME
SEGMENT ?N
17
DAY OFF
N
18 PRESSURE
ALARM?N
If PRESSURE ALARM is set to Yes
∆P FAN 1
19
20 INIT Pa REF?
If INIT Pa REF is set to Yes
21 m³h INIT
22 Pa REF
INIT
xxxx m³h
xxxx Pa
23 RESET
ALARMS?
24 END SETUP
Si # FANS=F1 + F2 : 2 fans
If F2=%F1 is set to yes: 2 dependent fans
14
% on K3?
15 %F1/F2
16 CONFIG
TIME? N
17 TIME
SEGMENT ?N
18
DAY OFF
N
19 PRESSURE
ALARM?N
If PRESSURE ALARM is set to Yes
∆P FAN 1
20
∆P FAN 2
21
22 INIT Pa REF?
If INIT Pa REF is set to Yes
23 m³h INIT
24 Pa REF
INIT
xxxx m³h
xxxx Pa
25 RESET
ALARMS?
26 END SETUP
Select multiplier of LS link when terminals +12V and K3 are closed ('night' setup).
Select Y to configure time and date. See § 3.2.1
Select Y to activate the time segment scheduling function. See § 3.2.1
Select Y if you wish to activate the day OFF option. See § 3.2.1
Pressure alarm is optional. If you do not wish to set a pressure alarm select N(o),
otherwise select Y(es). (not available for fans 720999 and 720998)
Configuration of pressure alarm on fan 1:
Select value of pressure increment corresponding to the nominal airflow
Configuration of pressure alarm: Do you wish to (re)define the nominal pressure
corresponding to a new nominal airflow?
If Y is selected, enter nominal airflow at which you wish to initialize the reference
pressure.
Initializing the reference pressure...
After +/-1 minute, the system will memorize the calculated pressure value of the fan
as the reference pressure. While initializing the airflow and pressure on F1 is
displayed.
Possibility to reset the alarms. Y or N?
The setup is then completed.
Select multiplier of LS link when terminals +12V and K3 are closed ('night' setup).
Choose the rate between fan 2 and 1 airflow
Select Y to configure time and date. See § 3.2.1
Select Y to activate the time segment scheduling function. See § 3.2.1
Select Y if you wish to activate the day OFF option. See § 3.2.1
Pressure alarm is optional. If you do not wish to set a pressure alarm select N(o),
otherwise select Y(es). (not available for fans 720999 and 720998)
Configuration of pressure alarm on fan 1:
Select value of pressure increment corresponding to the nominal airflow
Configuration of pressure alarm on fan 2:
Select value of pressure increment corresponding to the nominal airflow
Configuration of pressure alarm: Do you wish to (re)define the nominal pressure
corresponding to a new nominal airflow?
If Y is selected, enter nominal airflow at which you wish to initialize the reference
pressure. (same airflow for fan 1 and fan 2)
Initializing the reference pressure...
After +/-1 minute, the system will memorize the calculated pressures value of the
fans as the reference pressure. While initializing the airflow and pressure on F1 is
displayed.
Possibility to reset the alarms. Y or N?
The setup is then completed.
16