Restore System; Restoring Codes And Keys - CAME PXC08 Manuel D'installation

Restore system

m
Restoring parameters is irreversible and cancels all programming .
m
Restoring parameters does not delete the events memory .
To reset the control unit completely you need to restore both the factory settings and the codes .

Restoring codes and keys

Factory settings for codes and keys are:
CODES STATUS PASSWORD
1 ENABLED 123456
2 . . . n DISABLED Undefined
All the codes are restored; code 1 is set at: 123456
KEYS
1 . . . n
All the keys are restored .
To restore factory settings for codes, you have to:
CN2
P1
CN6 M6
STEP 6: Start up programming
1 .
2 .
•
•
3 .
Warning: the control unit is Autobauding and could require several seconds to
synchronise .
STEP 7: Putting into operation and closing the control unit
Once maintenance is completed, restore the system to operation .
1 .
2 .
3 .
4 .
AREAS
AUTHORISATION
ASSOCIATED
ALL ARMING + DISARMING
ALL ARMING + DISARMING
STATUS
DISABLED
STEP 1: Setting microswitches
1 .
CN3
STEP 2: Restart the control unit
1 .
SETTING UP
2 .
SW1
STEP 3: Reset microswitch
1 .
2 .
SETTING UP
IN PROCESS
F5
3 .
The control unit must be totally off .
PROGRAM. FROM PC
If the parameter
WITH CTL-U. OFF
•
AFTER USER CODE
•
user code .
Open the programming window, select the parameters to start up and press
start writing .
Go into the technical menu .
Put the control unit into operational mode by putting microswitch 1 down .
Close the control unit .
Exit the technical menu .
ASSOCIATED AREAS
ALL
Put microswitch 2 in the ON position .
Press button P1 to make the control unit restart .
SETTING UP
The words
display for 10") .
ON
1 2 3 4
Put microswitch 2 in the OFF position .
SETTING UP
The words
JP3
keypad .
At the end of setting up, the control unit returns to displaying the system
status .
M7
is:
, start up programming .
, before starting up programming enter the
REMOTE ACCESS TO
ASSISTANCE USER MENU
ENABLED ENABLED
ENABLED ENABLED
AUTHORISATION
ARMING + DISARMING
appear on the keypad (this stays on
IN PROCESS
appear on the