Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
ACQUIRING REMOTE READERS
The system cannot have readers with identical addresses .
All the readers are produced with address 1 and the control units have a built-in reader enabled at the factory .
For a new reader to be addressed and acquired by the control unit you must (example of adding reader 2):
08:23
16/05/10
123456
ENTER CODE
WAITING
222222
*=USER MENU
SYSTEM 02
▼ ▲
MODIFY
*
SYSTEM
*
INSERTERS
#--
INSERTERS
#--
08:23
16/05/10
123456
ENTER CODE
WAITING
222222
*=USER MENU
SYSTEM 02
▼ ▲
*
ADDRESSING
INSERTERS
*
ON INSERTER 02
APPROACH KEY
1.
2. - 4.
INSERTER OK
*
PRESS */OK
STEP 1: Enabling readers in control unit
1 .
To access the Technical menu hold down key
lowed by the User code (if less than 6 digits confirm with
2 .
Hold down key
3 .
With
4 .
With
5 .
With
▼ ▲
6 .
Use the number keys to select the reader to be enabled ( # = enabled, -
= disabled) .
▼ ▲
7 .
Press
2
#
STEP 2: Addressing reader
To assign the address to a reader you must:
1 .
Staying in the
2 .
With
3 .
The address of the reader not found on the bus, which needs to be ad-
dressed, appears on the display .
4 .
Approach a key (even one that has not been acquired) to the reader to
▼ ▲
which you want to assign the address shown on the display and wait
until the LEDs flash slowly and the buzzer sounds .
5 .
On the keypad,
▼ ▲
6 .
If there are other readers to be addressed the procedure will start again
from the beginning .
7 .
Press
/ESC # for 5 secs and enter the Technical code .
SYSTEM
select
and press
MODIFY SYSTEM
select
INSERTERS
select
.
#
to go back to the previous menu .
SYSTEM
menu .
INSERTERS ADDRESSING
select
INSERTER 02 OK
#
to quit and return to the previous menus .
/ESC # for 5 secs fol-
*
) .
*
.
*
and press
.
*
and press
.
*
appears . Press
to continue .
Publicité
Table des Matières
