Opening / Closing Control Unit; Use Of Control Unit Command Keypad; Accessing Technical Menu - CAME PXC08 Manuel D'installation

Masquer les pouces Voir aussi pour PXC08:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

OPENING / CLOSING CONTROL UNIT

If the control unit tamper is correctly installed, if you open the control unit door the sabotage alarm will immediately go off .
To avoid triggering the alarm you must access the technical menu from the keypad .
08:23
16/05/10
123456
ENTER CODE
WAITING
222222
*=USER MENU

Use of control unit command keypad

KEY
MEANING OF KEYS
,
, ,
*
#
C
D
Menu browsing and selection keys .
,
,
,
+
-
Parameter modification keys .
*
Once the code has been entered, it allows you to access the menus, or to confirm a selection .
,
,
A
B
C
Launch scenarios keys .
D
System disarm key .

ACCESSING TECHNICAL MENU

Depending on the parameter
menu may or may not be preceded by the User code .
Simultaneous access from more than one keypad to the technical or user menu is not permitted .
INDIRECT ACCESS
To access the Technical Menu press and hold down key
again for 5 seconds and enter the technical code
you can change the text .
5 sec
+
1
DIRECT ACCESS
With the system totally off, press key
+ -
Using keys
you can move from character to character, while with keys
5 sec
1
STEP 1: Opening control unit
1 .
Key in the user code (if less than 6 digits confirm with
2 .
Enter the technical code to go into the technical menu .
3 .
Open the control unit by undoing the relevant screws .
STEP 2: Putting the control unit into maintenance mode
To prevent alarms being triggered at the end of programming because of possible program-
ming errors, we recommend putting the control unit into maintenance mode .
1 .
Put the control unit into maintenance mode
STEP 3: Maintenance
This setting lets the user perform operations without the risk of unwanted sirens or telephone
calls being activated .
STEP 4: Putting into operation and closing the control unit
Once maintenance is completed, restore the system to operation .
1 .
Put the control unit into operational mode
2 .
Close the control unit within 30" before the control unit tamper alarm is activated .
TECH MENU ACCESS
CODES
(
/ESC # for 5 seconds, enter the user code
222222
. Using keys
123456
+
2
/ESC # for 5 seconds and enter the technical code
+
2
INSTALLER'S TECHNICAL CODE
->
+ -
you can move from character to character, while with keys
5 sec
+
3
222222
you can change the text .
222222
*
) .
by moving microswitch 1 up .
by moving microswitch 1 down .
), access to the technical
123456
, press key
/ESC #
222222
4
to go into the Technical Menu .

Publicité

Table des Matières
loading

Table des Matières