Oregon PN2500N Mode D'emploi page 88

Stubborn dirt can occur if:
- the oil in the fuel is too much and/or the oil quality is unsuitable.
- the air filter is partly obstructed.
1) Manually screw on the spark plug to the end of its thread to avoid
damaging its housing. then tighten the spark plug using the spark plug
wrench.
2) Do not carry out repair work on the chain saw (unless you are qualified to
do so). Contact an approved service centre for help.
Checking the screws, fixed and moving parts
- Before each use, please make sure there are no loose or damaged
screws / parts and that the bar and chain are not significantly worn.
- make sure the damaged parts are replaced by an approved service
centre before using the chain saw.
CLEANING, TRANSPORT AND STORAGE
Keep your machine clean, the outside of the machine can be cleaned

using a damp soft cloth with a mild detergent if required, never use water
to clean the machine as it may cause damage to internal parts.
Some maintenance products and solvents may damage the plastic parts,

these include products containing benzene. Trichloroethylene, chloride
and ammonia.
Take special care to keep the ventilation inlets /outlets free from

obstruction. Cleaning with a soft brush followed by a compressed air jet
will usually be sufficient to ensure acceptable internal cleanliness.
Wear eye protection when carrying out cleaning.

If the chain saw needs to be transported or unused for long periods of

time, empty the fuel tank.
Store the chain saw in a dry and safe room, not accessible to children.

When transporting or storing the chain saw, cover the guide bar and the

chain by using the guide bar cover provided.
If necessary, have the maintenance performed by a specialist or service

center.
GB
Fig.51
88