Oregon PN2500N Mode D'emploi page 57

or under the influence of alcohol or the drugs.
Maintenance and storage
a) Keep all nuts and screws tight to be sure the equipment
is in safe working condition.
b) Never store the equipment with petrol in the tank inside a
building where fumes can reach an open flame or spark.
c) Allow the engine to cool before storing in any enclosure.
d) To reduce the fire hazard, keep the engine, silencer and
petrol storage area free of vegetative material and
excessive grease.
e) Replace worn or damaged parts for safety.
f) If the fuel tank has to be drained, this should be done
outdoors.
g) Always clean and maintenance before storage.
h) Never disassemble the guards for cutting attachments.
i) Always store the metal elements in cool and dry place,
never use rusted chain or guide. It may cause serous
injure during working.
Transportation and handling
a) Whenever the machine is to be handled or transported
you must :
- Turn off the engine, wait for the cutting device to
stop and disconnect the spark plug cap ;
- Fit the cutting device guard ;
- Wear protective gloves when handling the saw
chain ;
When using a vehicle to transport the machine, position it
so that it can cause no danger to persons and fasten it
GB
57