Nice MhouseKit WS200S Instructions Et Avertissements Pour L'installation Et L'utilisation page 57

LED P1 [D] Status
Off * All OK
On Memorisation in Mode 1
Series of quick flashes, Memorisation in Mode 2
from 1 to 4
5 quick flashes Cancellation OK
1 slow flash Wrong command
3 slow flashes Memorisation OK
5 slow flashes Cancellation OK
LED P2 [E] Status
Off * All OK
On All OK
1 flash per second The device recognition phase has not been
carried out, or there are errors in the data
saved
2 flashes per second Devices recognition phase in progress
LED P3 [F] Status
All OK
Off *
On
All OK
1 flash per second There is no memorised opening angle
2 flashes per second
Opening angles auto-recognition phase in
progress
* or it could be in "Standby" mode
41
Action
No memorisation in progress.
During memorisation in mode 1, it is normal for it to take a maxi-
mum of 10 s.
During memorisation in mode 2, it is normal for it to take a maxi-
mum of 10 s.
Completion of deletion of a transmitter.
A command has been received from an unmemorised transmitter
Memorisation completed successfully
Completion of deletion of all transmitters.
Action
"Slow" speed selected
"Fast" speed selected
It is possible that there are faulty devices. Check and if neces-
sary repeat the device recognition phase (see paragraph 10.3.3
"Recognition of other devices")
Indicates that it is in the process of recognising the attached
devices (this will take a maximum of a few seconds)
Action
Cycle operation
Complete cycle operation
Carry out the recognition phase (see chapter "3.5.2 - Leaf open
and closure angles recognition").
Indicates that the open angles self-learning phase is in progress.
B
A
C
D
E
F
English – 23