Testing And Commissioning; Testing; Commissioning - Nice MhouseKit WS200S Instructions Et Avertissements Pour L'installation Et L'utilisation

Table des Matières

Les langues disponibles

––– STEP 8 –––

These are the most important stage in the automation system installation

procedure in order to ensure the maximum safety levels.

Testing can also be adopted as a method of periodically checking that all

the various devices in the system are functioning correctly.

Testing and commissioning of the automation must be performed

by skilled and qualified personnel, who are responsible for the

tests required according to the risks present, and for ensuring

observance of all legal provisions, standards and regulations, and

in particular all requirements of the standard EN 12445, which

establishes the test methods for checking automations for gates.

8.1 - TESTING

01. Ensure that you have strictly complied with the instructions

and warnings in STEP 1.

02. Using the selector switch or the radio transmitter, carry out testing of

opening and closing the gate and check that the movement of the

leaves corresponds to what is expected. It is useful to perform sev-

eral tests to evaluate the freedom of movement of the gate and any

adjustment or installation faults, as well as the presence of particular

points of friction.

03. Check the proper operation of all the safety devices, one by one

(photocells, safety edges, etc.). In particular, each time a device is

activated, the "ECSBus" LED on the control unit flashes longer, con-

firming that the control unit has recognised this.

04. To check the photocells and make sure that there is no interference

with other devices, pass a 5 cm diameter, 30 cm long cylinder (fig.

30) on the optical axis, first near TX, then near RX and finally at the

mid-point between them and make sure that in all these cases the

device is triggered, switching from the active to the alarm status and

LED P1

LP1

LED P2

LP2

LED P3

LP3