Charging The Randy Ii Fcc - PRESIDENT RANDY II FCC Manuel Du Propriétaire

Short press the VOX key (8) to activate (On) or deactivate (OF)
-
the NOISE GATE.
Noise Gate: Prevents amplification of background noises. This
results in optimized signal levels.
2) CTCSS/DCS
For simplicity, in this manual we will speak of CODE to indicate
both a CTCSS tone and a DCS code, of GENRE to indicate the
kind of code (CTCSS, DCS or OFF = no code). TYPE indicates
whether this is a TX transmission or an RX reception and MODE
specifies the operating mode, Identical I d or different DF.
Consult the CODE SET menu page 21.
See list of codes pages 60 and 61.
Note: Codes can only be used in FM. Each channel can have
its own code.
- Press the s or t key (3) to select the channel.
Press the PTT switch (14) and press the AM/FM key (10) to activate/
-
deactivate the CTCSS/DCS function.
Activation
If a CTCSS/DCS code has been stored, it becomes active, "CTCSS"
or "DCS" icon is displayed on the screen.
In I d mode, if no CTCSS/DCS code has been stored, the device
emits an error beep. Go to the CODE SET menu to store a CTCSS/
DCS code.
In DF mode, if no CTCSS/DCS code has been stored in either type
TX or type RX, the device emits an error beep. Go to the CODE
SET menu to store the CTCSS/DCS codes.
Deactivation
If a CTCSS/DCS code has been stored and "CTCSS" or "DCS"
is displayed on the screen, press the PTT switch (14) and press
the AM/FM key (10) to deactivate the stored code, "CTCSS" or
"DCS" disappears, a deactivation beep sounds. The memorized
CTCSS/DCS code is kept in memory but no longer functions.
G) CHARGING THE RANDY II FCC
1) USING THE AC POWER SUPPLY
1. Clip the home charger (C8) to the bottom of the unit in any sense.
is displayed when the function is active.
(PTT + AM/FM)
23